• Rear Panel I/O Ports:
  • 2 RJ45 LAN ports
  • 4x USB rear ports (Total 6 USB 2.0 Compliant / 1.1 Compliant)
  • 1 Fast UART 16550 serial port
  • 1 ECP / EEP parallel port
  • Stacked PS/2 keyboard and mouse ports
  
  
• Audio:
  • AC97 Audio
  
  
• SCSI:
  • Adaptec AIC-7902 Controller
  • Dual-Channel Ultra320 SCSI
  • Host RAID 0, 1, 10 support (only for 4 drives)
  • Support for Zero-Channel RAID with Supermicro All-In-One-ZCR Card: AOC-LPZCR1, AOC-LPZCR2 or AOC-LPZCR3
  • SCSI RAID 0, 1, 5, 10
  • Optional: (Card NOT included)
  
  
• Manageability:
  • ACPI/API Power Management
  • Main Switch Override Mechanism
  • Wake-On-Ring (WOR) header
  • Wake-On-LAN (WOL) header
  • Power-on mode control for AC power loss recovery
  • Internal/External modem remote ring-on
  • Monitors for CPU Cores, +1.8V, +3.3V, +5V, ±12V, +3.3V Standby, +5V Standby, VBAT
  • CPU Core 5-Phase-switching voltage regulator with auto-sense from 0.8375V-1.60V
  • Total of eight 4-pin fans
  • 8x fans with tachometer status monitoring
  • Status monitor for speed control
  • Support 3-pin speed control
  • Low noise fan speed control
  • Monitoring for CPU and chassis environment
  • CPU thermal trip support
  • Thermal Control for 8x fan connectors
  • PSU I2C temperature sensing logic
  • Thermal Monitor 2 (TM2) support
  • CPU / System Overheat LED
  • Chassis intrusion detection
  • Chassis intrusion header
  • Super Doctor III, Watch Dog, NMI
  • Optional IPMI (Intelligent Platform Management Interface) 2.0

Supermicro X7DA8 Specifications

• Model:
  • Supermicro X7DA8 Motherboard

• Processor Support:
  • Dual 771-pin LGA Sockets
  • Supports up to two Intel ® 64-bit Xeon ® processor(s) of the same type below:
  • Quad-Core Intel ® Xeon ®Processor 5300 sequence (Clovertown processor) up to 2.66 GHz
  • Dual-Core Intel ® Xeon ®Processor 5100/5000 sequence (Woodcrest/Dempsey processor) up to 3.73 GHz
  • NOTE: Motherboard PCB revision 2.0 or above is required to support Xeon ® 5100 (Woodcrest) processors
  • FSB 1333 / 1066 / 667 MHz system bus

• Chipset:
  • Intel ® 5000X (Greencreek)
  • MCH + PXH-V + ESB2
  
  
• Memory:
  • Eight 240-pin DIMM sockets
  • Supports up to 32 GB 667 / 533MHz DDR2 ECC FB-DIMM memory
  • Dual branch memory bus
  • Memory must be populated in pairs
  • Memory Mirroring supported
  • 667 / 533MHz FB-DIMM (Fully Buffered DIMM) ECC DDR2 SDRAM 72-bit, 240-pin gold-plated DIMMs 512 MB, 1GB, 2GB, 4GB 1.8V only, 1.5V(AMB)
  • Corrects single-bit errors, Detects double-bit errors (using ECC memory)
  • Supports Intel ® x4 and x8 Single Device Data Correction (SDDC)
  
  
• Expansion Slots:
  • 1 (x16) PCI-e slot
  • 1 (x4) PCI-e (using x16) slot
  • 2x 64-bit 133/100MHz PCI-X (3.3V) slots
  • 1x 64-bit 100MHz PCI-X (3.3V) slot
  • 1x 32-bit 33MHz PCI (5V) slot

• On-Board LAN:
  • Intel ® (ESB2/Gilgal) 82563EB Dual-port Gigabit Ethernet Controller
  • Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
  • Intel ® I/OAT support for fast, scaleable, and reliable networking
  
  
• Storage:
  • Intel SB SATA 3.0Gbps Controller
  • RAID 0, 1, 5, 10 support (Windows Only)
  • RAID 0, 1, 10 support (Linux)
  • Six SATA hard drives supported
  • Single EIDE channel supports up to two UDMA IDE devices(IDE-M, IDE-S) including CF card
  • Supports UDMA Mode 5, PIO Mode 4, and ATA/100
  • Compact Flash (40-pin connector, IDE 1, single channel) slot
  
  
• IPMI:
  • Support for Intelligent Platform Management Interface v.2.0
  • 200-pin IPMI slot (SIMLP)
  • (Optional: AOC-SIMLP-B)
  • (Optional: AOC-SIMLP-3) with 3rd LAN support
  • NOTE: KVM-over-LAN not supported - there is no DVO signal to the IPMI slot
  
  
• Form Factor:
  • Extended ATX
  • 12" x 13.05" (30.5cm x 33.2cm)
  
  
• BIOS:
  • 8Mb Flash EEPROM with Phoenix ® BIOS
  • Plug and Play (PnP)
  • ACPI 1.0/ 2.0, PCI 2.2, DMI 2.1
  • Hardware BIOS Virus protection
  • PCI-X 1.0
  • SMBIOS 2.3
  • USB Legacy support