• Storage:
  • Dual-channel master mode
  • Up to four Enhanced IDE devices
  • Support for ATA-100/66/33 IDE and ATAPI-compliant devices

• Rear Panel I/O Ports:
  • Four USB ports (two via back plate)
  • Stacked keyboard and mouse ports
  • Two 9-pin 16550-based serial ports
  • Lan Port
  • One 25-pin SPP/ECP/EPP parallel header

• Internal I/O Interface:
  • One floppy connector supports up to two drives: microfloppy support via optional cable
  • Two USB (via optional cable)
  
  
• Integrated LAN Controllers:
  • 3Com 3C920 ASIC with 3C905 driver set LAN
  • Supports 10Mbps and 100Mbps transfer rates
  
  
• System Management:
  • Winbond W83782D hardware monitoring ASIC
  • 3-pin chassis intrusion header
  
  
• Regulatory:
  • FCC DoC (Declaration of Conformity)
  • European CE (Declaration of Conformity)

Motherboard Specifications

• Model:
  • Tyan Tiger MPX (S2466N4) Motherboard

• Processor Support:
  • Dual PGA462 ZIF sockets
  • Supports up to two AMD Athlon MP processors
  • Two onboard VRMs (VRM 8.4 spec)

• Chipset:
  • AMD-760 MPX chipset
  • AMD-762 north bridge & AMD-768 south bridge
  • Winbond W83627HF Super I/O ASIC

• FSB:
  • 200Mhz/266MHz

• Memory:
  • Four 184-pin 2.5-Volt DDR DIMM sockets
  • Supports up to 4GB* of Registered DDR 200/266
  • Support for ECC (72-bit) memory module
  • - Note: The AMD-760 MPX requires a portion of memory to be reserved for PCI devices. Allocation for these devices is dependent on the number of PCI devices installed, and option ROM for each device. Common configurations will see 3.5GB to 3.8GB of available memory.

• Expansion Slots:
  • One AGP slot supports 4x/2x AGP
  • Two 64-bit 66MHz (3.3-volt) PCI slots
  • Four 32-bit 33MHz (5-volt) PCI slots
  • Total of seven usable slots
  
  
• BIOS:
  • Phoenix BIOS 2/4Mbit Flash ROM
  • User settings for hardware monitoring
  • Auto configuration of IDE hard disk types
  • DMI 2.0 compliant
  • Multiple boot options

• Form Factor:
  • ATX footprint (12" x 10.3", 304.8 x 261.62mm)
  • ATX & ATX 12V power connector configuration